I'm going to attempt to install Mod Tool 7.5 again and see if I can get it to run. Can I ask somebody to help me out with this? What I mean is: I have had several failed attempts at doing this before. Either I get an error trying to open anything in Mod Tool, or it fails to even start. If I post what's wrong as I experience it, can somebody help me fix these things?
Quote from: Gistech on April 28, 2015, 12:23:01 AM
I'm going to attempt to install Mod Tool 7.5 again and see if I can get it to run. Can I ask somebody to help me out with this? What I mean is: I have had several failed attempts at doing this before. Either I get an error trying to open anything in Mod Tool, or it fails to even start. If I post what's wrong as I experience it, can somebody help me fix these things?
I can try to install it at the same time as you. I have also had failed attempts, but successful ones, too.
What operating system are you using?
Windows Vista Home Premium 32 bit.
The first problem I have to solve is the installation running. My primary HDD has 1.5GB left ATM (this is where the installation puts its temp files) and I need a bit more room.
So, attempting install now.
I've had one error so far about not being able to unpackage a installation file as the process was already 'in use' before main setup and this cropped up so far:
[spoiler]Error 1403.Could not delete value C:\Windows\Installer$PatchCache|\Managed\b25099274a207264182f8181add555d0\8.0.56336 from ket Software\Microsoft\Windows\CurrentVersion\Installer\Folders. Verify that you have sufficient access to that key, or contact your support personnel.[/spoiler]
I'm on registering DLLs at the moment.
Okay, installation completed with no other errors to report, but it does require me to restart.
In the words of Anakin Skywalker...
Quote from: Anakin SkywalkerIT'S WORKING! IT'S WORKING!
I can successfully import and the ZETools are installed. Now I just need to figure out the interface (I'm used to Metasequoia) and if I can do that I can finally convert those kitbashes I had done in Meta and exported to OBJ.
I get an occasional error and I have to start it a few times to get it to work and manually install the ZETools each time, but it works.